Search:

I just bought a Supermax 19-38 specifically for the purpose of running cabinet doors through. So far, I'm impressed and it's cut my sanding time down somewhat. The end results are much better with it...

I get it Joe. The slab I bought was air dried and I knew that going into it. I never said I bought a KD slab.

Regardless, I had a good experience with the guy and his lumber is reasonably priced...

I purchased a large live edge walnut slab from him. I thought it was an excellent experience and a very reasonable price. You will not find a better price on walnut slabs around and you will not find...

You could use a cut off nail as a fastener to hold while glue dries.

Take a thin nail and pound part way into the vertical dividers of the carcass. Then cut off the nail leaving about 1/4 or 3/8...

I've had the same problem in the last 3 cans I've ordered. The propellant seems to be defective.

I just wanted to update. It's been about 1.5 months now. I've hosted a few gatherings and more than a few cold beverages have been placed on the top. I've been very careful to use coasters but...

The top had been finished for 4 days prior to the water ring problem.

Shop temp was between 60-65 degrees during application and drying. Jeff said proper temp is anywhere between 60-80.

I'll...

I spoke with Jeff this morning. He didn't see a problem with my finishing schedule but did recommend using the cross linker product. I will be looking into this next time. He also said that, more...

Thank you. I'll put in a phone call tomorrow and see what they have to say. I'll report back.

John,

If I scuffed the surface of my em9000 and applied a few coats of GF waterborne or Arm-r-seal would that solve my problem? I'd hate to sand the slab all the way back down to bare wood but...

I applied with shop temp between 60-65. Slab was 7-8% I checked it before starting to work it. Can of finish was brand new just shipped.

Slab had finish applied for about 4 days. It feels a...

Hello All,

I tried searching but didn't find anything quite like this. Long story short I'm building a small basement bar and the top is a live edge walnut slab. I left a can of soda on the bar...

I have the same problem when I build shop projects and they turn out half decent.... I guess it's not a bad problem to have :)

Dave I love the top to your miter saw cabinets and the levelers are a fantastic idea. Amazing how having a level and flat bench can be a game changer.

Two Projects for me.

Garage Cabinets:
http://i.imgur.com/EX0mZwA.jpg

http://i.imgur.com/Vz4M9eH.jpg


Installed a custom cabinet that I've been working on for a few months. First time...

Shoe rack for my closet302153302154

Just an update to this thread. You guys were correct. My wood piece was not flat and slightly bowed. As it was pushed through the table one edge would rock away from the bit ever so slightly but...

I'm not using either I'm just pushing through with hand pressure. I'm wondering if my plate is not leveled correctly. Do you gentleman have any methods or suggestions on how to properly level a...

I'm not necessarily trying to create a bull nose but if I were to route the round over across the entire board one edge would be of proper depth and by the time I get to the end of the board the...

Hey guys... I'm frustrated. I have a Rockler router table and plate insert. I have my Porter Cable 690 mounted in the table. As far as I can tell everything is square and true yet I keep getting...