Jon, would it be possible to unbolt the saw from the stand and carefully tip the saw over exposing the bottom side for your cleaning purposes? I hear what you are saying about realignment and I would...
Type: Posts; User: Steve Stube; Keyword(s):
Jon, would it be possible to unbolt the saw from the stand and carefully tip the saw over exposing the bottom side for your cleaning purposes? I hear what you are saying about realignment and I would...
Very nice Frank, thanks for the "as finished" pictures.
Well by all means Barry, keep us in suspense.
If that's a simple question, here is a simple answer. Determine the downstream total load (sum of the motor/s amps) multiply by 1.73 to choose the wire size needed upstream (plus a fudge factor to...
Joe,
"plus it won't do the detailed graphics/photos that we can do"
Do you mean like this example from the site?
http://www.carvewright.com/images/plastic_carving.jpg
Speak hole hardware;
http://www.nissenco.com/index.htm
Click on product overview.
Welcome to SMC John! Yes, I would agree that the item you are seeking does look very much like a "chrome plated" round soffit vent.
Jack, if you were to use one or two "steel or hard tired" fixed casters I think you would have little difficulty getting it rolling. A pull rope attached low on the unit (near the casters) will also...
Count me in. It's payback time via PayPal
Harbor Freight has a 20% off any single item purchase good thru tomorrow. If you want me to forward the e-mail coupon, PM me your address.
Ken, happy for your return and the good report.
Okay Bart, thank you.
What did you clamp it to? Do you have two tables on your sander? I think one table and only a small blade stop is the rule with these machines.
Looks like a good work-a-round but other than perhaps a glimps of the tails of 2 C clamps I can't see how you made the attachment. Would you share that detail also. TIA
Keep improvising, you are...
FWIW, The promise of a separate area for Shop Tours at SMC is pre July 2003. Hope it happens someday!
John, maybe you could splash a picture of that "older" bandsaw here so we can see what you are working with. My early 70's Craftsman 12" bandsaw came with an accessory platen and 1/2" X 80" sanding...
Aahah... I wondered if it was old enough to be by Red Star.
There is a manual, operating instructions, company history and a few photos at OWWM. I looked it up for a guy claiming to have a "like...
A car guy like yourself can point him in the right direction (bearing house) for the bearing once you get the number off the present bearing - assuming there is a present bearing. Cooling fin could...
Really FANTASTIC case!
Ducks.... had some in the yard Monday. Funny looking ducks, not much of a bill now that I think of it....
I think most alignment processes are trial and error. The blade to the table is the alignment that is necessary (sheetmetal stand is really out of the picture) and makes more sense to me to be...
Welcome to you both! Kent you are a great example of how folks here at the Creek offer their experience and help. We all have something to offer but not necessarily on every topic - and I am going to...
Very nice Jim, should be an attention getter alright!
Radio Shack has backer plates for some phones. If your wall phone is a modular (plug-in behind it), you unplug the phone pulg in the backer plate and replace the phone as before. The backer is about...
Rob, if you run a big enough cyclone (like the extra 5' dia. one I have), you can position it over your trailer outside and recycle and filter the warm air back to your shop. Dump it from the bottom...
My wife has a Pet grooming shop and with cage dryers, blow dryers and the vacuum going did miss phone calls now and then (lost calls > lost appointments > lost income). I installed one of the strobe...