Sounds like your saw blade is too long. verify required length.
Type: Posts; User: carl zietz; Keyword(s):
Sounds like your saw blade is too long. verify required length.
I have been looking at a project that has a lot of inlay work and have been looking at the veritas including string cutter accessories, and at the lee nielson model 71, any recommendations, or am I...
I built the chair and am building the ottoman, my wife is a seamstress and is doing all the cushions. Materials cost is going to be about 400 for the cushions. about the same as the cost of the...
Does any one have suggestions regarding brands of sanding belts? I recently tried Norton Metalite on my Powermatic Belt / Disk sander, and even being cautious regarding tension and light loading,...
We have Armstrong laminate flooring,chose it in part due to its being impervious to dog claws.
Hemlock / fir trim had conditioner pre applied, then Rodda stain applied. blotch is bad enough that some of the wood looks like a leopard print.
On some samples
photo 1 is stained without a...
I am looking for plans for a stand alone porch swing, I think also known as a garden swing. Any advice on where to find a good set of plans for a comfortable swing? This will go on the porch of a...
it works for me
Could use the new bits
depends where you live, in the swamp previously known as the pacific northwest, the normal choice is cedar, (redwood got too expensive). As a durability reference, painted and maintained cedar will...
It would look good in my shop, pls put my hat in the ring
Todd,
I have been doing it exactly theway you describe, and witht the same results. and since my tenons have shoulders, no one can see my dirty little secret that the joints are not smooth as...
Always game for a try
no comment, the wife just bought me a 17 inch JET drill press
Are you in for a treat, I made some lace pillow stands for my wife out of it. It works easily, and with just a natural oil finish, is almost seems to glow from within.
I would not think it is necessary. I just did a loose fit wood handle on a metal tang display dagger, used devcon 2 ton epoxy, and it is solid as a rock.
In the process of prepping to build my new house, I am going to have to take down an old english walnut. it is about 46 inches in dia 1 foot up from the ground, and has the typicla walnut umbrella...
In the process of prepping to build my new house, I am going to have to take down an old english walnut. it is about 46 inches in dia 1 foot up from the ground, and has the typicla walnut umbrella...
Thanks for the input guys, I think I will upgrade to the floor stand JET at this point. the LOML suggested it as a xmas present.
My Delta bench top drill press, approx 8 yrs old just had tensioner pulley failure, what is the likely hood of finding parts, and or should I just find a different drill press?
count me in.
i use hardboard for some cabinet backs, and have never had an issue. The routing comes from cutting the hard board a little large, screwing on the back, then routing a clean edge. The only challenge...
My daughter asked me to make a cane with for her to use as she recovers from hip surgery. it was not to be a walmart little old lady cane. it is a maple shaft, cherry head, with the shaft...
My daughter is going to be recovering from hip surgery and has asked me to make a cane for her, as she puts it something other than the aluminum walmart special. I found some instructions that use a...
While I know there are more expensive ones out there, I have a General 75-050TMI that I have been using the dickens out of for a couple three years as an avid hobbyist, and it has never skipped a...