Wasn't the charge of $85, it was the fact all he did was scrape the TC lead, replacing it with a new one would have been only a few dollars more and a much more professional repair.
Al
Type: Posts; User: Al Willits; Keyword(s):
Wasn't the charge of $85, it was the fact all he did was scrape the TC lead, replacing it with a new one would have been only a few dollars more and a much more professional repair.
Al
$85 to scrape a TC lead???
Considering how cheap they are I'd find a new tech, not very professional imho.
If he lights the pilot that leaves out electronic ignition, like said the pilot or TC...
Not sure...duct tape is the DIY first line of repair...:)
Good post Mike, you've done this before...:)
btw Natural gas can lose it odorant smell if it's run though the ground, especially...
Many now are going with a electric oven, gas top burner set up, best of both worlds and chances are all you'll have to do is run gas to the stove.
Al
We have the Weber Summit grill and it has both a smoker box and infra red rotisserie burner, best of both worlds.
Smoke flavor and convenience of propane.
We do turkey or chicken on the...
Sorry, better stuff as in Plywood, not glue.
It was Titebond 3 I was using fwiw
Al
On 1/2" ply from the borgs I'd bet you'll see swelling if you use Titebond, I did anyway.
Not sure on the better stuff though
And I used a piece of plastic sheet to shim like suggested, didn't...
I use the tap method and its worked for me so far but I could see the set screw being much quicker.
I think I'd set the fence up so it was slightly more than 90 degree's and use only one of them...
I'd think comparing BTU costs versus each source of heat would be the way to start.
Here in the Metro area Nat gas if by far cheaper than heat pumps, maybe not so in the area's that use Propane...
I'm betting your Amana is made by Maytag...:D
Al
Do a search on tankless and you'll find several posts, just make sure to consider all the costs before you have one installed, Bosch says (they make several brands of them) every two years to have a...
Nothing quite as fancy as some, but I work on a technical help desk for a Natural gas supplier that also does sales, service and repair of HVAC and assorted appliance's.
We have a service dept of...
Thanks guys, wondering if a coating of Johnson floor wax might make the dust flow a bit easier?
I'm getting by with the Delta Hybrid saw, but find it doesn't really like thicker pieces of...
Good point on the registration, hadn't thought of that.
Cop shop would be better I agree...:D
I use my drum sander probably to much, but no matter what I use it on, it requires some more work with a hand sander/ROS sander, 100 in the drum, then 120, 150, 180, and 220 gives a nice finish,...
Been giving a new tablesaw some thought, big step for me so I'm going pretty slow, but I've been reading a lot on the newer Delta 36-L352 saw and it seems to get both good reviews and have all the...
We've got two of the 255 and they work fine, neither will show our house but they'll show the neighbors and we can usually find our way home from their house...:)
I was told a tip, do not use...
If your in Florida, I doubt it's freon locked, in fact I'd bet on it, also for it to be oil locked someone would have had to added a lot of oil to the system.
You got sparks, you have more...
Is the sub self powered?
If not, your receiver may not have enough to power it.
Or you may be trying to power the sub when it has its own amp?
Al
Thanks guys, I think I can work this out so the cabinets above the microwave will be all glass and the same height as the other glass sections.
Ya, they would be to small to do a 2/3 1/3...
Outside unit usually just needs to be a disconnect, some put breakers there, but depending on your local code, usually a breaker isn't needed.
It could be shorted wire, bad condensor motor/cap,...
Putting together a set of kitchen cabinets for the wife, where planning on the door fronts being about 2/3 wood on the bottom with the top third being a glass section.
Question I have is what to...
Used to watch the trap shooters get pleasantly plowed while shooting clay pigeons years back, thank goodness that's been frowned on by most clubs now.
Another thought, watch the pharmaceuticals...
Check with manufactur for conversion kits.
Some water heaters may not convert, most dryers do, the Trane should, check before they run the line.
We do this all the time here at work, I work for...
Lori, I have a service manual for it if ya want, a 10 year old stove if in decent shape should get repaired, a newer one isn't gonna be any more efficent to run and a repair charge will be cheaper...