I agree
Dave
Type: Posts; User: David Klug; Keyword(s):
I agree
Dave
I just looked at the RAS I bought in 1966. It has black 1 in. stripes on the top sides with ruler measurements on it. Never did figure out how to use them. It also has pin striipes going across the...
I am immpressed!!!!!!!!!
DK
Glenn: I didn't have much money when I picked up my table saw. I got a 10" Craftman contractor saw and over the yrs. I upgraded it with a Vega fence and a Incra miter guage. I then built a roll...
Beautiful table Matt. OBTW How much Bud lite did it take to finish it?
DK
Randy, I have an old Delta planer with the same problem. The best way I've found to reduce the snipe so that you can sand it out is to pull way up on the board when it is exiting the planer.
OK Jim what is cheese steak?
DK
Beautiful table Dave. I'm more interested in the material that you used for the roof of the doll house.
DK
Dave; I have a 26" Vega fence and I can rip a 4x8 sheet of plywood down the middle with no problem and of course you can rip narrower strips if you want to. I have my extentions to the left of my TS...
That is really really nice Marc. I just finished a quartersawn oak cupboard that was 10' long for our church. It has the top sloped 25 degrees so they can display things on top of it. That was enough...
That's just beautiful Mark. I was wondering, when I look at the pictures it looks like it's about 10' long. Just what are the dimensions?
DK
That's just terrific Ed. My problem is I don't have enough imagination to come up with something as beautiful as that.
DK
Roland I made a bridge to flatten my work bench by building a bridge like they show. I was a little wider than the bench top and I used bed rails clamped to the edges for it to ride on. They have to...
I don't know how much rust you have on the table top but if it seems feasable to you what I would do is get a peace of glass 1/4" thick 6" wide and 2 or 3 ft. long and use some 80 grit PSA sand paper...
If you have access to railroad ties, they work good.
DK
I downloaded pkzip and I still get gibberish
DK
Todd that is just beautiful! I like the way you matched the grain on the corner.
DK
Great work Keith, I wish that I could see a picture of what it looked like before you turned it.
DK
Andrew I got rid of my Craftman fence and bought a Vega. The smartest thing that I ever did for my TS.
DK
Jim I like your drawing, looks like something that I would do. If you keep up with the step by step story you're liable to have your own TV show and give Norm a run for his money. LOL
DK
One of the things that you have to watch with a RAS is ripping ... pay attention to how you position the saw head. The saw head should be marked with lettering that says something like (DO NOT RIP...
It depends on the diamiter of the circle.
DK
This won't be much help to those who already own a good fence, but for those who a thinking about getting a new fence I highly recomend the Vega fence that already has the micro adjustment built in....
Scott on the project that I just finished I sprayed on 4 coats of poly then sanded it smooth with 375 w/d, buffed it with car buffing compound, then finished it up with rotten stone and water. It...
Eric I have 5 lights like you do and I just plug them into outlets that are mounted on the rafters. Most of the outlets are tied into a swithch so I don't have to unplug them.
DK