Give CSI a call 01179114367 they are the distributors for Epilog if they don't have it I'm sure they can point you in the right direction.
www.csionline.co.uk
Type: Posts; User: Frank Corker; Keyword(s):
Give CSI a call 01179114367 they are the distributors for Epilog if they don't have it I'm sure they can point you in the right direction.
www.csionline.co.uk
I have a four inch lens but to be honest, it does cut fine, but it doesn't engrave cast with the same crisp quality. As for the quality of cut on thicker materials it is supposed to be better but...
I think it's a sticky plunger too. The contact is right at the top of the black rectangular part that slides upwards. If you remove the plunger and then gently tap it up and down the contact will...
The demo shown on the YouTube for gluing the award to the base is scary. I would never lift the object. Movement that she had going there would have resulted in marking and wiping the cloth over...
Their prices are laughable!
Your power, speed and frequency are okay to cut the material. Obviously from the finish, the result is not what you want. In this case, you are using black acrylic, this for me is notorious for...
A lot of them have the same issue. Mine can take a minute or two before the tube is ready to fire. In the settings in the manual, there is a laser tickle that can be activated, but I never looked...
Well done Tim, good to hear a nice story every now and then.
Anything black, picture wise, should be done in negative.
That's looking very nice. Good colour too.
Steve is without doubt the right man for the job and one of the most knowledgeable. Good choice.
I thought it was an actor
From Dan:
I'd appreciate it if you would pass along I'm closing on a home next month, preparing for being out of the country for a few weeks, and trying to finish remodelling my current home...
He's on Facebook I'll let him know you were asking
I agree with Mike. Laser beam alignment, go to the Epilog website and view the tutorial or check from the manual. That metal tray is not generally used for cutting on, you should use your vector...
Graham, I have never had any issues with the venting problems, most of the time the smells are so minimal you can hardly detect them anyway. I work from home and none of my neighbours have had any...
That looks a little like acrylic sweat marks, where the vapour from the cut acrylic sticks to the shiny surface. Transfer tape might help prevent it. It might also be from having alcohol on it...
If you need help with these, you need to present better quality pictures definitely bigger than those you have put up here. Someone will most likely help, might I suggest you put the full size scans...
Stan they look nice but you seem to have a lot of banding in them.
Joe's analysis is spot on. Transfer tape will stop the hazing too.
From the Helix manual which can be downloaded from Epilog website.
All Epilog model 8000 laser systems require an exhaust fan that is rated
at a minimum of 400 CFM at 6” of static pressure 680 M3...
Josh a lot will depend on what you are using it for. Anything that smokes heavily, a lower cfm might not be able to exhaust the fumes out fast enough. On some materials, it can be hazardous and...
The 4" lens cuts okay, not a fantastic bit of difference. The engraving on acrylic is definitely not as good as with the standard lens, less frosty, on wood it is fine, I have to be honest and say I...
I think that the best rule of sum is the higher the dpi and resolution of the image the better, however there are occasions when too high dpi will result on too much damage to the image. Wood will...
Yup, that is impressive, but I can only see it being used for the purpose that was on the video. Looks pretty scary actually.