Search:

I got the same call after I ordered a warranty replacement tension shaft for my bandsaw. That was back on June 12th.

They are still using the move from TN to CA as the reason for the slow...

I hope you will share the name of that other vendor.

One of the problems I'm having is figuring out which of the posted kits on Carters site fits my saw. They gave me a number for my saw that...

Has anyone installed Carter guides on a 14" Steel City BS with a riser kit? Carter tells me they have a set of guides that will fit, but the guard will not. They tell me that some guys have...

While Cypress is an excellent wood for exterior applications, it is not very stable for a window sash. I use Vertical grain Fir for my sash.

So..... this guy screws the credit card company for the purchase by reniginging on the deal, and "we" all wind up paying for the crime with higher interest rates on "our" purchases.

Why in the...

Find a copy of "Make your own Handcrafted Doors & Windows" by John Birchard, ISBN 0-8069-6544-4. It is long out of print, but you can find nice copies on Amazon.

His book covers building double...

Mike,

I've had a lot of success using 400 or 600 grit wet/dry sandpaper in a palm sander with plenty of WD40. It takes a lot less elbow grease and will remove the surface rust very nicely.

Jim,

It's good to hear the the MM CU300 was able to fit through your 36" opening. While I've been waiting for more information from Felder, I came across a lightly used CU300 Sharp for half the...

I have decided to move up to a sliding table shaper to replace my router table, and replace my 6" jointer with at least an 8" model. The cost of both of these together will run at least $5000.00. ...

If you are really considering the Delta X5, I think you may want to check out the Grizzly G0452. From what I can see, they are exactly the same machine other than the dual voltage motor. You can...

That's a good point David. I hadn't thought of future mountings and modifications.


As far a stability, I thought the granite would not react to temperature changes like cast iron would, and...

I'm planning to move up to a shaper to replace my router table. I would like to find a shaper with a granite top for it's trueness and stability. My shop is in a basement room about 50 yards from...

Thanks for the advise guys. I'll use the thinned satin varnish for the sealer.

Actually Steve, I never found a flat to obscure the finish when it was top coated with a glossier finish. I...

I have a set of old oak dining chairs that I have stripped and preparred for finish. I plan to use McClosky's Heirloom oil varnish in a satin gloss. In the past I used to use a flat finish varnish...