Search:

Mike:

Don't overemphasize by comment about the adjustment range.

The coarse adjustment is very fast. i.e. when setting a bit to a height I just lay a reference bar next to the bit and run the...

Chris:

on the lift support columns there are a pair of lines representing the maximum and minimum travel range. The instructions call for adjustment of the router to the middle of this range -...

I purchased one direct from Woodpeckers. I really don't have a basis for comparison to other lifts as I have always used a Milwaukee 5625 with through the table adjustment. The lift is much more...

I purchased a Steel City shaper about the first of the year and I am quite happy with it.

I was real close to buying the Grizzly but - based on the Steel City Fall Special and rebate - the price...

I had excellent results with Steel City CS. When I recieved my shaper one of the fence adjustment knobs was slightly dented. After a call to CS I recieved a replacment within a week.

I got one of the Steel City Shapers just before the first of the year. I also have a Milwaukee 3 1/2 HP Router in a cast iron top Grizzley table. The fence system I have on the router table is one I...

This weekend I set up a Steel City Shaper. Very easy assembly!!

http://i145.photobucket.com/albums/r228/rbay_photos/SCShaper1.jpg

The fence is pretty nice.
...

I have had a 1073 for a couple of years. Generally I like the saw and - unless it had been abused - I would think the $400 is a good price.

The tension adjustment is not a quick release but it is...

Thanks to all for the advice.

Jim - I did see the review and pictures of your Incra Fence mod. Real nice idea.

J.R. - I have looked at the Freeborn site and will probably order some bushings...

Is it safe and practical to run a 1 1/4" Shaper Cutter on a 1" or 3/4" Spindle? I am looking at buying one of the 3HP Import Shapers and the largest Spindle these come with is 1".

To do this do...

I've been using the 1073z version of this saw for about a year. I believe it is the same with the exception of the enclosed base.

I am quite happy with the saw in that it has done a good job on...

I have the benchtop version of this drill press - the G7945. In general it is fine.

Some of the hardware is a bit flimsy but no more than I would expect for a product of this cost.

This...

I purchased a 50" Left Tilt Unisaw from Woodcraft around the 1st of December.

The alignment of everything was good "out of the box". The saw has worked quite well on everything I have tried.
...

I've had one of these tables for about a year. In this time I have mounted three different routers in the table. The first time I was very unhappy with the mounting system. After working with it I...

I would appreciate any input on the Delta X5 Unisaw. I have been looking at a Grizzly 1023SL or one of these for a while. The sales on the Delta look attractive.

My main concern is the various...