Search:

Sounds like the play is in he bearings.

John

Have you checked the alignment with the blade tilted? If not, check it out. Maybe your table is not set up for a bevel cut. Try cutting with the blade at 90deg. If it cuts ok it probably needs set...

I think this is black walnut.

If You like the natural look but dilike the hole , I would simply finish the piece as it is then have a piece of glas cut to the exact shape as the top and put it down. This way youget the look of...

Lost quite a few jobs locally. As an outside vendor to companies like Coleman, I have seen alot of poorly run companies. Coleman was one of the worst. My company lost some money to them.

John

When I looked at the plates on the Benchdog website it shows the aluminum plate is standard with two reduction rings. The Pro plates are offered in three opening options. Go to (www.benchdog.com)...

I had the accident that this device is suppose to prevent. I slipped and my right middle finger tip contacted the blade. The interesting part was this. The skin of my finger tip never touched the...

Brian,
If you are spraying small lots at home. You should consider water based products. I use Target coatings and really like it. Alot safer to spray with alot of the advantages of solvent based...

I have been hesitant to post to this thread becouse I am one of the statistics spoken of. About one year ago I lost the first joint of my right middle finger in my table saw. The accident happened...

Perry, Do'nt close the holes off completely. If you stop the flow of air you will stop the removal of dust. You may need more flow not less. I tried the magnetic covers on my Jet saw and it made the...

I purchased the festool rotex sander and vacuum package. I am very happy with the sander and vacuum. I do agree with Dave on the poor manuals. I also have the saw and guide and like it. The saw does...