Search:

No running TEST doesn't Fire anything.

Hi everyone, I have a ULS-PS50

All the the sudden my beam as stopped firing. I ran a job all was well, next job it ran the file (went through the motions of the engraving and cutting but the beam...

I used to be able to get a clean cut through .5" acrylic no problem with my 50W.

296493296494Thanks for all the replies, here are the mirrors in question. Would I be power loss based on this wear? It's a pretty old tube so I'm not getting near 50w in the first place. I assume...

ULS-P50
50W. Laser

I'm in need of new mirrors for my laser, both the mirrors are pretty much worn and flaked away around the outter edges, where's the most econimical place to find them? It's a...

I'm often looking to break or cut up and delete different sections of a vector. Generally I try to do it using the virtual segment deletion tool that said whenever I do it the image either disapeiars...

sorry should have mentioned that but it was the first thing I did, give everything a good clean.

ULS-P50
50W. Laser

It would appear that all of the sudden I'm no longer able to cut through the most basic woods at any of the settings i've mastered over time. I'm trying to cut 1/8 wood and...

Specs:
- ULS50-PS
- Running on Windows XP via VM Fusion 4.0 (on a mac running Lion)
- This issue only started happening after I upgraded my Fusion to 4.0

The issue being when I go to run a...

I did a quick look Dan, didn't see any.

Hi All I have a request to do a family tree piece but I can't seem to find just the right tree... I'm sure some of you fine folks have folders and folders worth of tree. Any help would be...

I'm working with some bamboo and I'm having a hard time nailing down good engraving settings. I want good detail levels, clean burn, etc. Can't seem to figure out my speed and power... as for PPI I...

:) count me in

Long story short unless you're really, really new at this (the laser just showed up in your garage) I wouldn't recommend it. Your time would be far better spent holed up next to your laser and this...

Not sure if anyone happens to be a laserhead/lawyer but I've got a question on copyright.

I'm sure i'm not the only one to troll the web looking for inspiration with the eye "I can do that on my...

Frank,
I was going to address this request right to you but I thought better of it... Thanks!!

Happy New Year all!
I was hoping some kind soul out there might have some Chandelier's on file? Any help would be appreciated!

Thanks Louis, fantastic!

here's the file saved as a crd 12

I'm trying to work out how to do a few things in Corel. I'm trying to make a name plate necklace like the "Helen" picture I've attached. I've been asked to use a specific font which isn't a solid...

it looks like all four corners are a little out of level from each other. How can I can about leveling out the table?

Thanks everyone, I'll give that a shot, I thought I checked everything but I'll give it another try. The only thing I can think that I did inbetween when it worked and didn't is clean the cutting...

Hi again folk, I've run into a bit of an issue I *think* my beam is out of alignment and/or may table is not true across the whole surface.

Top left corner of the bed (18 x 24") everything is fine...

Thanks all, i'll try everything when I get home... one of those things is bound to work

I'm running a ULS laser (hairline red to cut) I'm importing a photoshop eps file, running a outline line art trace, creating a boundry and right clicking for my red hairline... all that said when I...