Charles, I'd love to here your logic for your choices of options.

For reference, I'm leaning towards:

2800mm slider length - to clear the blade while ripping/crosscutting 8' panels or boards.
1500mm outrigger table - for size and capacity
43", small crosscut fence - I'll use this for mitering smaller boards while the outrigger is not mounted.
Two eccentric clamps - self explanatory
31" rip fence - I do most ripping on the slider
Parallel cutting device - Makes ripping longer boards on the slider easier.
Router spindle - To use roueter bits with shaper unit
Remote start on slider - convenience
Mechanical digital readout on shaper height and saw tilt - for accuracy
Mechanical scoring
Precision mitre indexing
Cast iron extension

For the jointer all I was going to get was the digital power drive.

I use a Leigh, FMT for most mortising, so I doubt I'd get my money's worth out of a mortiser.

Any suggestions on shaper cutters? I do a lot of template routing, and lately, I'm pushing the upper limits (on size) of what a router can handle. Is there a good template following shaper head you'd recommend? A lot of my templates are curved. Will I need the small shaper head for curved work?

Regards,

John