Originally Posted by
Tom Welch
Your welcome Mike. John I was not refering to your post. But was refering to Jason's .
"this works well since I normally run a full kerf blade, and the splitter is slightly narrower. When I do put in the thin kerf blade its the same width as the splitter, "
I did not mean to ruffle anybodys feathers. Sorry if I did.
No promblem Tom, as I should have been more through when I went back to see just what you were referring to. I should have read Jason's post more cloesly. It takes much more than a gap in communication to get my shorts in a wad.
Bottom line... I got you Lima-Charlie (loud and clear) at this point.
Regards for the day, sir...
Sarge..
Woodworkers' Guild of Georgia
Laissez Les Bons Temps Rouler