..Grrrrrr. I keep getting the following problem: I like to gang plane the edge of boards. I usually run for or five at a time at about a sixteeth take off. I am getting beveled edges. About three to four degrees. I planed a hundred feet of poplar Friday and had a beautiful job. Dead on accurate side to side. Ran some 1x4 pine today on edge and the $*#@! beveled the edges. Is it my bed rollers? I have them set at 3 degrees. Should I set them flat? This really hacks me to no end. And, if anyone could persuade Bill Tindall to sign on the "Mill", we all would be better off for it. He is a fountain of knowledge and we surely could use his input.