So, I finally got to buy my first batch of rough sawn wood. I took it over to the jointer and jointed the face on one side and jointed one edge getting everything perfectly square and true. I then took the boards over to my new DW 735 and started running them threw to get them planed down to 3/4. Everything turned out really nice except for one thing. After planing some of the boards had a slight bow in them on the side that I planed. It was nothing I couldn't work around and probably better then the refinished boards I was buying before. But I started wondering should I have run the board through the planer and then flipped it over and run it through on the other side and keep repeating this process until I get to my desired 3/4 thickness?