With the insulation and sheet rock up its time to figure out how I'll wire the shop. I'm leaning towards conduit of some type and the single white, black, and ground wiring spools vs Nomex. I'm only going to have one 15 amp for the lights only (with a back up light in case the power goes out during a cut) the rest will be 20 amp for 120 volt circuits.
I'm still wrestling with the delta planer and the 612 wood master planer/molder and my window heat/ac unit. They alone will draw 55 amps. I have a 100 amp sub panel in the shop. My box is getting small real quick!!!!!