Laser Cut machine

[Amr Hosni]

Hello to all

This is my first participation in this site and I hope that I find help here.We have laser cut machine with 80w Co2 tube .We face a problem in the installation of the workpiece, such as veneer .And The table size is 2810×1570 mm .What preferred in the making of this table .And Iam thinking in the table working by vacuum pump to fix the workpiece.

Do i find same one Help me here or not

[Dan Hintz]

If the veneer is relatively flat, you can use magnets to hold it down, but generally you'll want a vacuum vector table for vector cutting...

[Amr Hosni]

Thank Den To post a reply , But the question here is how to chose the capacity of vacuum pump With the knowledge that the table will be Vinaigrette and the size is 2810 × 1570 and the thicness will be about 50:70 mm . And treadmill from the inside .

[Dan Hintz]

For my laser, I don't use a vacuum table, I simply use a honeycomb vector table and a dust collector. The dust collector is 1HP and pulls plenty of vacuum on the table as long as the unused portion is covered.