I already have the feeder(DELTA 36-850 1/4-Horsepower). Bought it new from someone here on the Creek. They had bought more than 1 at a store closing.
John, I am not sure what you meant by " I made my fence board wide, that way I can mount the feeder to the fence. " I have not seen them mounted to the fence. I thought they were usually mounted to a "back corner" of the table??
I have a Bnech Dog floor model router table (not a cast iron top). I had thought I might put a rectangular/square steel plate on the undrside of the table where i mount the feeder for stability.
Any thoughts on that?

Jim