You are just going to have to look at the motor plate and report. The spec page shows 2 different motors, neither match what you mentioned (480v motors are VERY common in industry). If it is a 480V single voltage motor you will be looking at a new motor more than likely. It MAY have a AC vector drive already on it but if it does most likely it will rewuire some form of power you don't have. If you have to replace the motor single phase may be your cheapest choice, or you may want to go with a 3 phase 230 motor and a VFD for braking and/or soft start, the saw already is variable speed but for wood you probably want to run it full plast but some people like a lower band speed for tall resawing. That should be a monster when sorted, although being a metal saw it is probably not set up for wide blades, maybe 3/4" max.