Hey Greg, Ive had lots of help here. I used the ring, but cut it to make it smaller so it would fit on top of a trash can. This also allowed me to use the inside baffle as a ramp as this part now became a little larger than the circumference, better if I show pictures.
No filter, motor over original ring then trash can underneath.Hope this may give you more ideas.
25- position of coil and cylinder to Thein Baffle.jpg24- unit with top and the Thine baffle unit at (top right).jpg22- coil baffle atached right side up.jpg23- coil baffle detale upside down.JPG21- origional baffle split and reshaped to partial coil.jpg
Reply With Quote