Air assist question

[Uros Sovilj]

Hi

I have used for air assist compresor from local store with 12l tank and 8 bar max.. It was quite noise and it's died few days ago. I was planing before to by compressor for airbrush for cermark use. It has 1/2 HP, max 4 bars(60 psi), air flow 135 l/min.
Can i used it for air assist for my engraver since i don't like to have two compressors in shop? Will it be strong enough?
I wuold like to use it since it's quiet and it's relative cheap compare to silent compressors with more power and bigger tank.

Regards

[Joe Pelonio]

I have been using a similar airbrush compressor for 5 years, set at 25 lbs and no problems.