i had a beam to dress down one side. I had used an axe to get rid of most of the buggy wood. just stood to one side and swung the axe down until most of the "bad" wood was laying on the ground. Brought the beam into the shop, and started a scrubbing down. i had a H-F 33 that was converted into a scrub plane. then i grabbed the jack plane from Worth.SDC12478.jpgand then the wood bodied #129. I was trying to remove just enough wood to make this side flat. I even ran the #8c down it a few times. then, finally, the smooth planes showed upSDC12477.jpg Most of the planes i used on this were from my Rust Hunting. Hey, I buy users..SDC12479.jpgLooks like an Angry beaver was here, don't it?