This is my first attempt at joining the forum. I purchased the Raptor Setup tool/jig's and have the following question. But first let me explain the frustration I have. The Raptor instructions state that they can be used to set the grinder/wolverine tool rest angle. After several attempts I could never get the proper angle as stated on the Raptor tool. I used the "tilt box" to determine the exact angle of the rest and here are my results - I will list the four Raptor settings and then what my "tilt box" angle showed. By the way the "tilt box" angle measurement can be determined by establishing a "zero" reference point which I did. What I want to know is whether anyone out there has taken the time to do this and what were your results? If you haven't checked it would you give it a try and let me know the what you find? When I use the compass to verify my tool angle it is correct. I am very reluctant to use the Raptor set up tool to set the grinder tool rest position.
Raptor "tilt box" difference
40 deg 40 degrees right on
45 deg 32.5 degrees 12.5 degree difference
50 deg 30 degrees 20 degree difference
60 deg 25 degrees 35 degree difference