Finding studs behind plaster and lath

[Peter J Lee]

First, see what you can surmise from the existing structure such as heating vents. With the grill off you can often see and poke around with a wire and figure stuff out. Electrical outlets are typically mounted on studs. With the plate off and power off, you can often learn where a stud is. Use that info and lay a tape out and given starting and ending points you can often have a good idea before you drill.

The nature of hand plastering often leaves a very slight wave pattern with crests on the studs. Try holding a flashlight against the wall in low light. Its a pretty sure bet on ceilings.

[John McClanahan]

+ metal detector.

[Michael Weber]

Never tried it but have read on some old house forums that a magnet works to find the lathe nails.

[Bruce Darrow]

Thanks for all the replies.

[Jim Laumann]

First, see what you can surmise from the existing structure such as heating vents. With the grill off you can often see and poke around with a wire and figure stuff out. Electrical outlets are typically mounted on studs. With the plate off and power off, you can often learn where a stud is. Use that info and lay a tape out and given starting and ending points you can often have a good idea before you drill.

The nature of hand plastering often leaves a very slight wave pattern with crests on the studs. Try holding a flashlight against the wall in low light. Its a pretty sure bet on ceilings.

One caveat about the tape measure idea - I owned a "old lady", and her studs spacing was - shall we say, approximate......

Some were 24 OC, but then again, 23 and 25" were entirely possible too.

Sure do miss that house - she was a lot of work, but she had features that no new house does....

Jim