I recently set out to build a split top roubo out of white oak. A friend of mine help me process the oak 2x6s and glue up the tops. After gluing up I left the tops in clamps overnight. The next day (nearly 24 hours) I removed the clamps and found some delamination. This is almost definy due to the 20 degree temps. I think the shop reach 35-40. I tried to pry off some of the boards where the gaps are largest but they seem pretty well stuck. At this point I have a top with up to 1/8" gaps between the boards in spots but there is still enough good long grain glue surface to prohibit a clean detachment. What are my options?? Should I fill the cracks with epoxy? Or should I try to release the glue joint and start over?