I am trying to get a New Hermes 3000LT with EP Module running from Engravelab 9. I own Engravelab but have not used it much.
My goal is to get this running with diamond drag. I have another New Hermes Engraver with electronics I rebuilt and run from different software, and I want to compare the diamond drag quality with the New Hermes 3000.
I created a small plate and wrote ABC on it, and sent it to the EP module. At this point I have no cutter installed - just air cutting.
The X and Y go through the motions of the letters correctly, but the spindle does not move up and down at all. As I recall this is a software setting someplace, but for the life of me I cannot find. it.
If anyone can think of some things to try I would appreciate it.
Thanks,
John