Dirty Engraving

[Robert Tepper]

I do a lot of red/white 1/8" Rowmark Laser material.

I clean everything with denatured alcohol and have good results for cleanup.

Robert

[Kev Williams]

I stumbled onto a 'combo' concoction yesterday that worked well, at least with gooey edges and soot from cutting-

My Turpentine wasn't within reach, but Mineral spirits was nearby, so I used that to rub the edges and clean the face (white/black Rowmark). Mineral spirits takes forever to evaporate so I followed up with a dose of DNA-- The pieces dried almost immediately, and no soot anywhere...

Not sure about cleaning out red yet, but I like how it worked on the black edges and white top surface--