I'm looking for a quality drill/countersink combo that won't break the bank.
I have a cheap set of stamped sheet metal spade type countersinks that I have used for years. I can't remember where they came from. Problem is, I've lost a couple of them. They always worked fine. Can't find anything like them now days.
I purchased what looked like a quality setup by Kobalt, at Lowe's. Drill/countersink on one end, driver bit on the other, with Allen set screws holding the driver bit and drill bit so they could be replaced. Even purchased the 4 bit replacement set for it. Total cost $20. Went to use them and the quick change holder was so poorly made that the drill bit scribed a circle around the location for the hole. I returned the mess to Lowe's. What brand/type do you use and would you recommend it?
I have 2 decent cordless drills(Both Firestorm), so quick change from drill to driver is not a strict requirement, quality, adjustability, and affordability is. Also like the capability to change the drill bit, and adjust it's length if necessary.

Chuck