OK so I owe an apology to you all and especially Grizzly. I feel like a complete moron! The lathe wouldn't start or run because I didn't supply the proper power. In my haste to run an outlet for the lathe I failed to connect both poles. Along with wiring an outlet for the lathe I also put in new LED's for the shop and other outlets for hand tools and when I was at the box I wired the lathe like the other circuits and connected one pole and the the other wires to the neutral and ground bus. I figured it out last night and couldn't believe it! I connected the other pole and its running perfectly. Wow this thing is amazing! I have only turned on my midi lathe with a 10" swing and no variable speed so this lathe feels like I went from a Kia to a Ferrari! I turned some new handles for the banjo and the tailstock out of curly maple so I could acclimate to the variable speed and get comfortable with the controls. I filed down the spindle shoulder so my chuck would go on as well.