Hey everyone, I've done a couple Powder Coated Yeti's and Ozark Trails and even through the P.C. finish is different I still get the same results. I always get a color haze left over on the stainless. I have read on here and other websites that if you scrub it with rubbing alcohol or Goo Gone it will comes off. I haven't tried goo gone but I have tried other things and it seems to lighten it some but always leaves a stain of the original color.

I try to hit it pretty hard, despite what the material database says to use.

I have a 30 watt ULS 2.3 and I have been hitting it with 100%P, 50%S and 500ppi. The material database in the driver says 36%p and 100%s.

Here is the last one I did, this was with me scrubbing the hell out of it with alcohol. Its more pronounced than the camera shows.

Is that the nature of the beast?