I purchased some 2 1/2" W x 1" H Alumamark plaques.
In Corel 12 I made a page the exact table area of my engraving machine 24" x 18. I created a rectangle that was the exact dimensions of the Alumamark piece. When I went to print, it is about 1/8" off. I dragged the rectangle up to the top of the page guidelines. Is there a shortcut to lining up an object to a guideline? I know if you click on an object and then another you can do a E and a C to center it horizontially and vertically. I wonder if my guidelines are off by a fraction, though I enlarged the page 5000% and saw nothing abnormal.