Results 1 to 8 of 8

Thread: How to size assembly table base

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 04-13-2020, 11:43 PM #1
    Ben Helmich
    Ben Helmich is offline [OP] Contributor
    Join Date
    Sep 2018
    Posts
    114

    How to size assembly table base

    I’m building a Ron Paulk style assembly table/out feed table. It will be permanent, not mobile. Dimensions of the table will be 62” long by 47” wide. It will have drawers and cabinets underneath. It will go all the way to the ground, no room for a toe kick. My question is how far to reduce the base to have room for my feet. It seems like it would be uncomfortable if it was the same size as the top. Thinking about three inches. Would you use over extension drawer slides? Thanks,
    -Ben
    Last edited by Ben Helmich; 04-14-2020 at 12:09 AM. Reason: Bad typer
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules