wow, that could have been much worse, glad it was not.
wow, that could have been much worse, glad it was not.
I think the stick took most of the damage...
Ash Scrap Project. was a pushstick.JPG
No, the red is not blood. It is paint from a Millers Falls rehab paint job...
Ash Scrap Project, PROPER pushsticks.JPG
That just happened to line up with the slot. Zero Clearance Overlay.....the other two objects ARE my two pushsticks.....Yellow one from Menard's the other is a home made for thin rips....
Used the yellow one this afternoon...
Ash Scrap Project, trim an edge.JPG
trimming a few edges straight....
Ash Scrap Project, lid stock.JPG
From these to..
Ash Scrap Project, lid panel.JPG
This. May try a glue up this weekend?
Glad it wasn't worse Steven. Thanks for the safety reminder!
It IS healing..slowly..
March work day, healing, still hurts.JPG
Still hurts...
Was trying to use a plane, today..
March work day, shavings.JPG
Jointing a few edges to do a glue-up...
March work day, panel glued up.JPG
Also needed to sharpen two items...a Millers Falls Type 2 No. 14...
March work day, both need sharpened.JPG
And that little 3/4" wide chisel....still not happy with how they turned out...
May need Andrew's sharpening system....I do have the Unicorn available...
I suppose I should start another "Build Thread"? Something about a March Project?
May just name it as The March Project Box?
Clamp handles are still a bit "ouchy" when I tighten them down...
March Project, back glued up.JPG
At least I can use the tote on the plane better..
March Project, thin a side.JPG
We'll see....