I just bought a new table saw. It is a craftsman 22124. I love the saw. Very, very happy with it but the dust collection sucks. I opened up that red door on the side and found a bunch of dust on the bottom slope but it wasn't going into the dust collection port. I stuck my hand in the dust and felt a strong draft but unless i pushed the dust to the port it wouldn't suck it up. My dust collection is not the best. I have a Delta 1 1/2hp 1200cfm collection. Should i build an overhead dust collection for the table saw, should i sell my right arm and get a bigger cfm dust collector, get a portable dust collector to drag around, or just elimate the dust collection all together and keep cutting some mdf till i can't see 5ft in front of me then pass out . Thanks for your opinions. Also if any of you have overhead dust collection please post some pics. Thanks Josh