Hi everyone I’m new here and kinda new to woodworking. I was searching for a table saw and came across this jointer for 150 bucks and felt like it was a good deal ( I hope so lol). Everything works on it. Everything checks out with a straight edge. I would like to disassemble and clean and lube it up. The in feed table is a little sticky. My question is can I remove and clean it without screwing up the adjustments. Right now with a straight edge everything looks good, except the far end of the infeed table drops slightly. Haven’t stuck feeler gauges in there yet. And also what kind of lube should I use. Probably something that doesn’t attract dirt. Thank you ahead for any input you guys have.