Hi there,
I recently picked up some pine pocket hole plugs for a project I am working on, and was quite surprised to find how challenging they were to install.
In particular the plugs just seem to large to fit easily and so I have resorted to different ways of hammering them in, all of which results in some damage to some part of the plug, which is fairly delicate at the taper.
I believe that Kreg has a jig for this built into their micro pocket hole jig, but I don't have one of those handy. I have also read about using a trim saw to taper them, but this seems like a lot of work.
Does anyone have a suggestion?
Thanks.