So I've turned 2-3 Barons in the past month or two and I'm having a hard time getting the super smooth sanding job I want. I've been sanding to 400 grit and then switching and going through all the levels of micro mesh but I'm still left with some deeper scratch patterns than I'd like. They aren't real noticeable unless you hold the pen at an angle with with very good lighting. From what I can tell they are scratches left from the 150 grit but even with extensive sanding with with the 250 through 400 I'm having a hard time removing them. On one of the pens I sanded for what seemed like an eternity with the 1500 MM and that seemed to take care of it but I'm assuming there is an easier way. Any suggestions on what I might do to either prevent these scratches from the start or remove them more effectively? Am I just being too picky?