I mostly cut poplar and pine with my Delta 10" bandsaw using a 1/4" blade. This week-end, I will be cutting red oak (3/4"). Any suggestions on blade TPI and thickness. According to the manual I could use a 1/2" width blade. Thanks for your help.
Jim
[OP]
Member
I mostly cut poplar and pine with my Delta 10" bandsaw using a 1/4" blade. This week-end, I will be cutting red oak (3/4"). Any suggestions on blade TPI and thickness. According to the manual I could use a 1/2" width blade. Thanks for your help.
Jim
Posting Permissions
Reply With Quote