Results 1 to 6 of 6

Thread: 56Degree Bevel

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 10-06-2004, 10:22 PM #1
    Joe MC Donnell
    Joe MC Donnell is offline [OP] Member
    Join Date
    Oct 2004
    Posts
    1

    56Degree Bevel

    Hi Everyone,
    New member, 1st post! How can I rip a 56 degree bevel on the edge of some 8quarter stock? The bevel gauge on my table saw only goes to 45degrees.

    Thanks for your help,
    Joe Mc
    Last edited by Joe MC Donnell; 10-06-2004 at 10:24 PM. Reason: Incorrect degree reading
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Bevel cuts on jointer-Problems!!
    By Mark Stutz in forum General Woodworking and Power Tools
    Replies: 1
    Last Post: 03-13-2004, 12:52 AM
  2. Spent the Morning with my Old Green Friend the Tormek
    By Mark Singer in forum General Woodworking and Power Tools
    Replies: 3
    Last Post: 01-02-2004, 3:05 PM
  3. Re-beveling the bevel edge chisel
    By Matthew Springer in forum Neanderthal Haven
    Replies: 2
    Last Post: 11-04-2003, 4:31 PM
  4. Attaining bevel w/o bench grinder
    By maurice biddles in forum Neanderthal Haven
    Replies: 4
    Last Post: 09-11-2003, 9:38 AM
  5. Bevel Cutting Jig - Good Idea?
    By John Ellison in forum General Woodworking and Power Tools
    Replies: 1
    Last Post: 08-23-2003, 10:35 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules