I am attempting to build my first workbench and was using ideas I saw on the web. I noticed, for dogs, some had square holes and some had circle holes for the dogs? Which is better and why? Honestly, I would prefer the cheaper, in cost not quality, route.
My thoughts are: First, I can make square dogs from Maple or some other hardwood, much easier than circle one. (Table saw or Miter saw for square ones over Lathe for round ones) Second, which may be a downside is I already have the top for most of my workbench glued, so the square hole would only be on the width side of my top. That's all I can think of right now.
Thanks for your input.
Reply With Quote