Hey everyone,

I bought a used PC892 a few months ago to use in my router table and I hadn't really used it much up until a couple of weeks ago.

I've noticed a couple of things and wanted to see if anyone knew what the problem or problems are.

First, it makes an odd grinding type sound when running. It doesn't sound like my PC690 at all.

Next, I've noticed an occasional spark down by the motor openings near where the collet attaches.

Finally, I've noticed the bit occasionally takes a second to start spinning. By that I mean the motor sounds like it's going, but the bit doesn't start spinning immediately. A fraction of a second later the bit starts spinning.

Any ideas?

Paul