What do any of you guys use to "sand" between the coats? I used 220 grit and go by hand. Minwax's Polyurethane brushed on with the poly-brush didn't give me "lines" free looking finish. I didn't like the finish and had to lightly sand it but it still shows streaks from the brush. I thought about the cabinet scraper and tried that on the coat and it did "level" out the "ridges" and "dried on drips" very easy. I started to use General Finishes' Polyacrylic Blend on that Minwax, it did blend out the "mistakes" very nicely. I always liked General Finishes better than Minwax's. Ever thought of using the cabinet scraper on between coats?