Been using pocket hole joinery for awhile and every time I use it I seem to have a problem with the pieces flushing out on the face. Yes, I use the Kreg clamps - both the 90° in the drilled pocket hole and regular for holding it flat to the surface ..... but ....... always seems to be a variable result with more times than not the face being slightly offset on one side of the joint from the other due to the screws at an angle in the pocket. Perhaps I need to REALLY crank down on the clamps?
Any others having similar problems ...... or solutions. I know this is a very popular method, and I do love it, but am frustrated with the seeming lack of repeatable accuracy and flush face joints if I don't pay REAL CLOSE attention to each and every joint (which should be done anyway!).
Feedback, comments, ideas greatly appreciated!