I have a CU 300 Smart and thinking about getting the router spindle/collet for the shaper so I can run router bits. Can somebody tell me if I need to buy just a collet or do I have to buy another/special spindle and collet or do I need something else completely? I'm guessing a special spindle with a collet. Also, approximately how much will this set me back$$? I am just kicking around the idea as I would like to use the sliding table with the router but my guess is it will not make sense cost wise. I tried asking MM, but it has been difficult as they won't tell me anything unless I have a part number and I really don't know exactly what parts I need (nor did they as the manual is not really clear).

Thanks

Mike