I have had my Zing for about 8 months, I think the time I took to evaluate different vendors and products was well spent. I am very happy with the product.

My problem is the table inside that goes up and down, it's not level and I am unable to find any documentation on the Epilog website with instructions on how to level the table.

My email request has gone unanswered, which is very unusual for Epilog.

So I am turning to the creek for answers.

How can I level my table? The back is higher then the front, so when I vector cut the beam isn't focused properly near the front.

I can disable the X/Y and drop down the focus pin and move it around the table and see about 1/8" difference.

Thanks
Zach