I've got a 24 aggazani with single phase, and I usually give the top wheel a few spins to help it get going. It starts OK on a 30 amp breaker.

I think that bandsaws are made for VFDs,

Is your supply 220 single phase, and you are trying to run 380 V three phase? What is the nameplate info, volts, amps, hz?

I was able to put a phase converter together for my table saw for just a few hundred dollars using a idler motor.

None of the solutions are really all that complex, depending on your willingness to scrounge.

My initial thought is to use a transformer to go form 220 to 440, then use a vfd to run the saw. The trick is that most 400 volt class drives are only rated for three phase supply. Some Hitachis allow the use of external dc supply, where you supply rectified filtered juice to a terminal on the drive.