About two years ago I built a roll around cart for my shop that I could use for a work bench. I just don't have enough room for a full size stationary work bench. Well, there were several problems with the first one. First, I did a 2x4 construction for the legs and frames. The problem with that is the 2x4's just used up to much vertical height so when it got to storing my power tools underneath the bench, there just wasn't enough room. Also, I built drawers on both sides of the bench. Problem with that is I was always going to the wrong side to get something. Third major problem was the sice. I made it 32"x48" and it was just a little too small. A few pictures of the old cart first.

DSCF8548.JPGDSCF8546.jpgDSCF8547.jpg