I post about how I had made my DC on the router table and it has worked out very well until now.
http://www.sawmillcreek.org/showthre...router-cabinet

I got a new lift and it would not fit the old DC set up I had.

So today I redid the whole thing, I took this opportunity to redesign it a little and it works just as good if not a little better then the older one. I still get some of the larger chips in the bottom but there is NO dust.

The new one is tighter around the lift and it is made like a box and it is bolted to the underside of the router table, Jessem had some pre-drilled and tapped hole so it made it easy to bolt it on. I made the port smaller in the back where the hose connects, this keeps the dust from building up in the corners.

I took the router table off the base and turned it upside down which made it much easier to work on and get everything lined up.


P1245290.jpg P1245294.jpg P1245296.jpg