Not having any luck getting to the CorelDraw newsgroups, so I'll try here...

The simplest statement of the problem is as follows:
Three lines are drawn on a blank page, but not through a common intersection. This results in a triangle bounded by those lines. How do I make a shape that corresponds to that triangle?

In the more general case, how do I create shapes that correspond to the regions bounded by an arbitrary number of open curves?

I've tried every obvious combination of selecting the lines and using the 'shaping' commands (Trim, Intersect, etc)...no joy. I suspect that exporting the drawing as a bit map, using flood fill to color the regions, and then bringing the result back in through CorelTrace will work, but that seems ridiculously kludgy.

Any ideas?