an overarm blade guard/dc?? I've got a General 350 TS and thought the overarm blade guard/dust collector would be a good add on. So I built the overarm from WoodCentral's plans. I really like it, but...! I've also found that it limits the use of the miter gauge if you're going to keep the guard down low enough to still suction sawdust. Before, I had a 1"x3" board for an extension screwed to the miter gauge. Now, if I'm crosscutting a board, I would have to raise the guard up far enough to go over the 3" MG board which lifts it too far to catch any sawdust. So, now I've just been using the MG to the right of the blade. No big deal but kind of a pain. Anyway, I've got a Rockler $50 gift cert from another order. Right now they've got the Incra 1000HD on sale for $120 w/free shipping. I thought of using the gift cert with this, which would make this a pretty decent deal. But the fence is to the left which means the blade guard would always have to be up so high. Now...finally my question! Who has the overarm setup, and how do you accommodate a miter gauge fence with it?? Thanks. Greg