I like to use pocket holes in some of my wood working but one thing that always frustrates me is how you can torque your alignment out of square when tightening your pocket screws. Case in point, I was was butt joining some drawers the other night with my Kreg jig and no matter what I tried the drawer parts would misalign or not be flush from the canting of the pocket hole screws. I used two of the vise grip style clamps but it still misaligned the drawer. I finally just switched over to butt joining the drawers with my Dowelmax. Not as quick but so much better alignment. I'm assuming this canting or torquing issue is just a drawback of using pocket holes.